This section teaches you how to insert light fixtures on your drawing.
Open drawing e-site in the 03 Creating Light Fixtures folder, or continue to use the drawing you were working on in the last tutorial section.
1. | Run the Insert Light Fixture command.The Insert Light Fixture dialog box will open. |
Ribbon: DM Photometrics->Light Fixtures-> Insert Light Fixture
Pulldown Menu: DM Photometrics->Insert Light Fixture
2. | Set Mounting Height to 20. |
3. | Make sure that Callout is set to S, Tilt is set to 0, and Layer System is set to New. |

5. | You will be prompted to insert the light fixture on the drawing by specifying the insertion point and rotation angle. Insert light fixtures on the drawing as shown below. |

6. | Run the Insert Light Fixture command. The Insert Light Fixture dialog box will open. |
Ribbon: DM Photometrics->Light Fixtures-> Insert Light Fixture
Pulldown Menu: DM Photometrics->Insert Light Fixture
8. | Set Mounting Height to 8. |
10. | Make sure that Layer System is set to New. |

12. | Insert light fixtures on the drawing as shown below. |

|